I've always dug this guy's character design. Nice and sleek yet also frighteningly deadly. Shriek was made from an Assassin figure from Speed Racer. The arms were basically cut off right below the shoulder joint then replaced with ones made from epoxy putty. The claw fingers were cut from a plastic bubble. The boot, belt, and underwear details were dremeled off and then re-smoothed with epoxy putty.

Shriev's head was also made from epoxy putty. Due to the short work time involved with epoxy putty, I decided to forego sculpting the facial details and opted to paint them in later.

The helmet is removable and was made from Milliput. Why milliput? I have no clue. I just wanted to test that stuff out. Although I liked how it didn't stick to the face too much while I was sculpting it. The mono eye was made by making a pen cap impression in the milliput. Once the milliput dried it made a nice fit unto the head, snug yet easily removable without damaging the paint on the figure's face. The paint details still need a lot of touching up but I doubt I'll ever get around to fixing them. Lazy bastard.

4/01